N ( lbs.) At Flat Center. Mechanical Specifications. Dimensions in inches (mm). Installation, configuration and maintenance must be carried out by qualified tech- nicians only. You must have detailed information to .

NEMA , 2 and frame sizes. This 4-wire bipolar stepper has 1. The motor was specified to have a max current of 350mA . Most motors have torque ratings. This is what you need to look at to decide if the motor has the strength to do what you want.

Step Angle, Torque-Up to 4. USA stock, off the shelf. A at V, allowing for a holding.

Output shaft supported by two ball bearings. More specifications are available in the datasheet (189k pdf ). This is one of the most popular stepper motor in Nema size, it with 1. It has wires with 1m cable and 2. A, with holding torque 45Ncm (64oz.in). This stepper motor is ideal for the RepRap Prusa, Mendel 9 Rostock and similar 3D printers, . This is an updated version nema stepper motor with holding torque of 59Ncm( 8oz.in).

Based on old verstion, we have lengthened motor cable length to metre, and add a 4-pin 0. Harwin female connector at the end of cable. However, its size is not an indication of its power. You can quickly develop your precision stepper motion control system by combining the NI stepper motors with NI Motion Assistant, LabVIEW, motion.

It can also be used in general control, automation and robotics applications. All models shown smaller than actual size. Technical Specifications. OMEGA offers a robust line of 2-phase biploar step motors.

Datasheet available under documentation tab.